VTR - Vinyl Adhesive Stripes for Jumping Poles (1 pack)
Vinyl adhesive stripes for poles - Perfect for PVC poles use and some wood poles applications which must be clean from dirt and other materials (fits poles with outside diameter up to 4.5").
Included: 10 stripes per pack for the 7.5" wide option and 5 stripes per pack for the 15" wide option. (please select option below).
Usage: Typically about 10 - 7.5" stripes per poles or 5 - 15" stripes.
Application Time: should take you about 15 minutes per pole for 10 - 7.5" stripes.
Application Direction: Very easily applicable by spraying water on surface and on adhesive side before applying.
Directions (PVC Poles): Wet the surface before applying VT Vinyl stripe(s). If needed you can wet the sticky side of the VT. Then lightly stretch the VT around the pole. Then with an old credit card squeegee out any excess water and bubbles that may be found. Any small bubbles will disappear under the sun in couple days.
Directions (Wood Poles): First make sure surface is clean from dirt and grease.
Attention: light sanding of wood poles with a fresh coat of clear stain is recommended before applying VTVT Vinyl stripe(s).
Uncoated wood you can Apply VT directly without any water.
Coated Wood you can wet the surface before applying VT. If needed you can wet the sticky side of the VT.
Then lightly stretch the VT around the pole. Then with an old credit card squeegee out any excess water and bubbles that may be found. Any small bubbles will disappear under the sun in couple days.
Attention: Shipping is included in price with orders over $99*, if its less a $14.99 shipping
charge will be added at checkout.
_thumbnail.jpg&maxx=63&maxy=0)
_thumbnail.jpg&maxx=63&maxy=0)
_thumbnail.jpg&maxx=63&maxy=0)
